19" Amplifier with 1000 Watt Power, Gain Control for each Channel, SpeakOn Sockets for Loudspeakers, XLR Sockets for Mixing Console, Limiter and Protections
The 2-channel amplifier transmits and amplifies all signals of sound system to the loudspeakers. Over both SpeakOn sockets the amplifier is connected with the loudspeakers. The amplifier has for each of the two channels of its own gain control with LED display for the output signal. To connect the mixing console or for through-connecting signal the amplifier is equipped with 2 XLR inputs and outputs. After connecting the power amp is switched on and the amplifier performs a self-test. The LED lights for the power supply. The amplifier is protected against overheating or connection to a power supply. When protection is automatically switched on, the amplifier is turned off and the fault indicator lights. The broadcast of the signals is protected by the limiter with LED display against distortion because signal level is too high. The height of signal level can be read on the signal LEDs. The power amplifier is prepared for the installation in 19" Racks.
Technical Data of Amplifier:
- T.H.D. (at rated Output power): <0,1%
- crosstalk (ref. 1 kHz, at 10% rated Output power): <-80 dB
- frequency response (ref. 1 kHz): 20 Hz ... 20 kHz (0~2 dB)
- input impedance (20Hz...20kHz,balanced): 20kΩ / balanced, 10 kΩ / unbalanced
- damping factor (at 100 Hz/1kHz 8 Ω): >450
- signal to noise ratio (A-weighted): 105 dB
- 3-pin XLR sockets: 2 x XLR male, 2 x XLR female
- 2 SpeakOn outputs
- protection: audio limiters, high temperature, short circuit
- cooling: front-to-rear
- dimensions (W x D x H): 483 x 335 x 88 mm
- weight: 14,2 kg
For ordering you announce yourselves please. We de-energise you then as dealers! |
